• Sign Up! To view all forums and unlock additional cool features

    Welcome to the #1 Dodge, Jeep and RAM Forum dedicated to FCA owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the SRT Forum today!


Catch can proof

Stormtrooper1320

Poster Club Hall of Fame
Founding Member
U.S. Marine Veteran
Member ID
#1068
Messages
10,407
Reactions
34,578
Likes
352
City
Bran
State
Non-US
Country
Romania
Vehicle
Panzerkampfwagen 150
#21

HRJ

Active Member
Founding Member
Member ID
#1045
Messages
478
Reactions
1,043
Likes
117
City
Houston
State
TX
Country
United States
Vehicle
Porsche GT3
#22
it's keeping oil from getting in the S/C system.
Is that a bad thing, though?
 


Marc W

3000 Posts Club
Founding Member
U.S. Navy Veteran
Firefighter
8 Second Best E/T
HFCOTM
Member ID
#993
Messages
3,421
Reactions
10,964
Likes
302
City
St. George
State
UT
Country
United States
Vehicle
2016 Dodge Challenger Hellcat
HFCOTM
View Images
#23
My take is this..... while a little bit of oil getting into the intake isn’t going to be a disaster, a can isn’t going to hurt and it’s a good way of assessing your motor. A tight motor that has a good seal around those oil galleys in the cylinder head is going to see almost no oil at all in a can. If you have increased your boost with pulleys and you don’t have a good seal there, then you’re pressurizing your crank case and a can is a good way to check that. I have one of these...... 259C51A9-EB32-4169-9C48-F45DD5547ACB.jpeg 7B44DE8A-1DF3-4179-87D0-B5E81C1F02DA.jpeg 974E6D00-E9F0-4EDC-8CAB-EC128A9D8A3D.jpeg
 


SilverBillet

4000 Posts Club
Founding Member
Donating Member
Member ID
#1009
Messages
4,275
Reactions
14,751
Likes
252
City
The Villages
State
FL
Country
United States
Vehicle
2021 Jeep GC 5.7 TrailHawk
#24
A loose motor revs faster. Oil in the catch can doesn’t mean the rings aren’t seating?
 


Hellcatcfp

5000 Posts Club
Staff Team
Founding Member
Donating Member
HFCOTM
Member ID
#1027
Messages
5,824
Reactions
37,930
Likes
402
State
CA
Country
United States
Vehicle
2018 Dodge Charger SRT Hellcat
#25
Why does this happen with the 6.2? The 6.2 is port injection vs direct injection...so I'm assuming it is somewhat normal? I agree that it cannot hurt to keep things clean with oil catch can.
 


Marc W

3000 Posts Club
Founding Member
U.S. Navy Veteran
Firefighter
8 Second Best E/T
HFCOTM
Member ID
#993
Messages
3,421
Reactions
10,964
Likes
302
City
St. George
State
UT
Country
United States
Vehicle
2016 Dodge Challenger Hellcat
HFCOTM
View Images
#26
A loose motor revs faster. Oil in the catch can doesn’t mean the rings aren’t seating?
I didn’t say it was rings. The cylinder head uses o-ring intake gaskets and the ring around the oil galley is known to be commonly compromised. That oil galley leads to the crankcase. Engines that see a lot of oil in a catch can, most likely have a problem there.
 


Mean Cat

4000 Posts Club
Founding Member
Donating Member
9 Second Best E/T
HFCOTM
Member ID
#997
Messages
4,981
Reactions
9,438
Likes
302
City
Houston
State
TX
Country
United States
Vehicle
2017 Challenger Hellcat
#27
That's where I think the FI spacers can help that issue ^^^.
I don't get that much oil in my CC , maybe 1 tea spoon but I still would not run with out it.
 


Mean Cat

4000 Posts Club
Founding Member
Donating Member
9 Second Best E/T
HFCOTM
Member ID
#997
Messages
4,981
Reactions
9,438
Likes
302
City
Houston
State
TX
Country
United States
Vehicle
2017 Challenger Hellcat
#28
Is that a bad thing, though?
I don't think it's catastrophic , but I don't think it's a good thing , if your car is 1 of the ones that get a lot oil in the Hellcat S/C system or intake system on NA cars ?.... then it could lower your effective octane level when it's trying to reburn that. Not to mention a oily mess inside those systems too.
I just don't see the down side to using a CC.
 


SilverBillet

4000 Posts Club
Founding Member
Donating Member
Member ID
#1009
Messages
4,275
Reactions
14,751
Likes
252
City
The Villages
State
FL
Country
United States
Vehicle
2021 Jeep GC 5.7 TrailHawk
#29
I didn’t say it was rings. The cylinder head uses o-ring intake gaskets and the ring around the oil galley is known to be commonly compromised. That oil galley leads to the crankcase. Engines that see a lot of oil in a catch can, most likely have a problem there.
I guess I need to replace them on my 5.7 because there is some oil accumulation on the top edge of the heads between the intake and valve covers. I guess it’s to be expected after 137,000 miles!
 


Last edited:


Top